Promat PROMASEAL® Fire Pillows can provide permanent protection from the spread of fire, but
they are particularly useful when only temporary protection is required.
Promat PROMASEAL® Fire Pillows have been successfully fire tested up to 120 minutes.
Promat PROMASEAL® Fire Pillows are used to maintain the fire resistance of walls and floors
where openings for services are located. They are typically installed around cables which need
to be regularly altered.
Promat PROMASEAL® Fire Pillows have been tested in accordance with the principles of
BS 476: Part 20: 1987.
When exposed to fire the pillow contents expand to fill even the smallest gaps around services,
creating a rigid barrier against the spread of smoke, toxic gases and fire.
- Fire protection for up to 120 minutes in walls and 120 minutes in floors
- Simple installation
- No additional material required
- Suitable for clean room applications
- Maintenance free
- Allows rearrangement of services
- Attractive, professional appearance
- Resistant to vermin and rot
Promat PROMASEAL® Fire Pillows are normally installed by laying in courses to completely fill
the gaps around penetrations. Where required to form adequate overlap, the smaller sized
pillow, 330mm x 200mm x 25mm, may be used at ends of layers of pillows.
Where, for example, non-combustible pipes or cables penetrate the Promat PROMASEAL® Fire
Pillows installation, care should be taken to ensure that a good seal is formed around such
penetrations by the use of smaller Promat PROMASEAL® Fire Pillows compressed into the gaps.
When installing the final layer of Promat PROMASEAL® Fire Pillows it is advisable to insert it
between the previous two layers by pulling it into position using the flap located at one end of each
pillow. This provides a tighter seal than trying to insert the final layer as the uppermost layer.